Carbide burrs are tools used for deburring most hard materials like ceramics, stone, steel, aluminum, plastics and hardwood. They provide precision, which enable it to also be employed in cutting, shaping, grinding and chamfering hard materials.
Carbide burrs can be utilized with a number of materials like metals (including Steel aluminum and cast iron) and all varieties of wood. You can use it on acrylics, fiberglass and plastics too. Carbide burrs takes a long time without chipping or breaking in order that it’s so excellent to use them on soft metals like gold,platinum and silver.
Do you know the Aspects of Carbide Burrs In comparison with HSS Burrs?
Compared with HSS, Carbide Burrs less complicated harder.
The Tungsten Carbide is incredibly hard in order to be used in wider range of work than HSS (High Speed Steel).
HSS can’t be as good as carbide burrs when they are at warm. Carbide Burrs can bear hotness and may run longer time.
Carbide won’t soften at high temperature but HSS burrs is opposite. There’s no question that carbide is the perfect choice.
Using Carbide Burs:
For more stability, insert the accessory bit to the tool and then back it slightly before tightening along the collet nut or keyless chuck.
Avoid using these for drilling holes or enlarging holes which can be under twice the diameter in the cutter. The tungsten carbide surface can certainly catch the medial side of your hole and break the bit.
Use higher speeds for hardwoods, slower speeds for metals and slow speeds for plastics (in order to avoid melting at contact point).
Start at the lower speed. Then increase on the speed that gives the most favourable results.
Don’t apply excessive pressure. It can slow down the spindle and chip cutting edges. Let the bur perform cutting.
Use the sides with the cutter for effective cutting. The top cuts poorly and can break pressurized.
Never in-capsulate the bur from the cut. If chattering occurs, increase speed.
When utilizing aluminium and magnesium, consider some kind of lubricant, wax or tallow, mainly because it may help avoid the flutes from loading or packing.
Carbide burs, if used the correct way, will outperform HSS burs by 50
More information about SD-51 Carbide Burrs you can check our new web portal